MAGNETIC FIXING for Goset G20 backstand

Complete MAGNETIC FIXING grinding system for Goset G20 and G20 PRO cutlery backstands. This MAGNETIC FIXING grinding system for Goset G20 and G20 PRO backstands is composed of a support arm, a magnetic plate on HIWIN guides of 250x50 mm, a dial indicator and a contact wheel Ø160 mm wit...

More information
Dimensions Stock Price
L'unité/Unit Bientôt disponible
€694.20 €578.50  Excl. Tax

Technical sheet

Customer reviews

Further information

Sous-catégorieMachines et accessoires

DIMENSIONS

Longueur6 mm

Complete MAGNETIC FIXING grinding system for Goset G20 and G20 PRO cutlery backstands.

This MAGNETIC FIXING grinding system for Goset G20 and G20 PRO backstands is composed of a support arm, a magnetic plate on HIWIN guides of 250x50 mm, a dial indicator and a contact wheel Ø160 mm with grooved polyurethane coating with a hardness of 90 Shore A.

Robustness and precision for this MAGNETIC FIXING grinding system for GOSET G20 and G20 PRO cutlery backstands.

This grinding device allows to work pieces up to 6 mm thick.

The moving table with permanent magnets offers a remarkable rigidity and precision of work thanks to the HIWIN guides, the German specialist in rail guidance.

Equipped with a dial gauge, this MAGNETIC FIXING grinding system for Goset G20 and G20 PRO knifemakers' backstands is particularly valuable in knifemaking workshops for the precision grinding of knife components: blades, plates, springs, sole plates or bristles.

Simple, quick to use and easy to operate.

Made of a strong square tube with a large cross-section, this MAGNETIC FIXING grinding system for Goset G20 and G20 PRO cutlery backstands can be installed without tools in a few minutes with great ease. Once the machine is stopped, simply remove the support arm supplied with its work table and rear plate, slide the arm into the dedicated housing, then install and tension the grinding belt on the Ø160 mm contact wheel with grooved polyurethane coating. Finish by tightening the support arm with the quick clamping device.

This device is used in a horizontal position and, after the installation of the unit, it is sufficient to unlock the tilting system and turn the belt sander/backstand upside down.

Do not forget to tighten the locking device again.

Note: a convenient thumbwheel device, located on the outside of the housing, allows the belt to be safely centered on the contact wheel when the machine is in operation.

 

Copyright 3801 - Total or partial reproduction forbidden without the authorization of SPAP SOUCILLE.

Customer reviews

Share your opinion
Secure payment

Opt for our secure 3D secure payment system, Paypal or bank transfer.

Quick delivery

Secure shipping in France in 72H, packaging adapted to the products.

customer service

We are at your disposal at 04 73 80 67 45 Monday to Tuesday from 9h to 12h and from 14h to 18h / Friday from 8h to 12h and from 14h to 17h

day-to-day shipping

For any order placed before 13h your parcel is sent the same day